1 / 5
Snap-in TPU/TPE feet for Densium APU / Densium 4 case (fits the 6.5 mm vent holes) — image 1
1 / 5

Snap-in TPU/TPE feet for Densium APU / Densium 4 case (fits the 6.5 mm vent holes)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Flexible feet that snap into the vent holes of the Densium APU / Densium 4 case. No glue, 4 mm lift, no more sliding.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
16
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Share Alike

Small snap-in feet for the Densium APU case (and the Densium 4, which shares the same bottom panel). The stock case comes without feet; thin adhesive pads work, but they look like an afterthought and the aluminium case still slides around on a desk.

These feet push into four of the 6.5 mm ventilation holes in the bottom panel. Printed in a flexible filament they grip the desk, lift the case 4 mm and need no glue.

HOW IT WORKS

  • The stem is exactly 6.5 mm, the same as the vent holes.

  • Above the stem is a snap lip that is 0.55 mm larger per side. Push the foot through from the outside: the flexible lip squeezes through the hole and springs back on the inside of the panel. The foot can't fall out, but you can still pull it out again if you ever want to.

  • The disc is 15 mm x 4 mm with a chamfered edge, so it covers the hole pattern neatly and looks like it belongs there.

  • Designed for a 2 mm bottom panel.

Pushing them through takes some force. Put the case on its side, press the foot in with your thumb and give the disc a small wiggle. A drop of water on the stem helps.

If the fit is too tight or too loose for your case or filament, scale the model a few percent in the slicer. The STEP file is included if you want to change the stem or lip size.

PRINTING

  • Flexible filament, Shore 95A TPU or ~45D TPE. Softer (85A) will work but holds less firmly in the hole.

  • Print as oriented, disc on the bed, stem up. No supports: the lip overhang is only half a millimetre.

  • 0.20 mm layers, 3-4 perimeters, 30% infill. The feet are tiny, so this costs nothing.

  • Slow: 20-25 mm/s, minimal retraction. The Prusa Generic FLEX / Prusament TPU 95A profile works out of the box on a CORE One.

  • Textured sheet, or a smooth sheet with a thin layer of glue stick as release layer. Flex filament bonds very strongly to bare smooth PEI.

  • Dry the filament first. Wet TPU/TPE strings and gives weak layers, exactly where the snap lip needs its strength.

  • Four feet: about 4 g and 18 minutes on a Prusa CORE One.

FILES

  • densium-snap-in-foot.stl / .step: one foot, print 4x

  • densium-snap-in-foot-4x_TPE_CoreOne.3mf: PrusaSlicer project, 4 feet, FLEX profile

  • densium-snap-in-foot-4x_0.2mm_FLEX_COREONE.bgcode: ready to print on a CORE One with 0.4 nozzle

Not affiliated with Densium. Hole size based on the Densium 4 v2 specification (6.5 mm, 8 mm pitch), confirmed on my Densium APU.

Tags