Nakamichi Cassette Deck 1/1.5/2 Rotary Potentiometer Knob
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement knob for rotary controls on a series of Nakamichi decks from the 80s.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 14
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
I am restoring a Nakamichi Cassette Deck 1.5 from the 80's. The rotary controls on this deck and a series of similar ones use a recessed knob to attach to a 6mm D-style potentiometer shaft. I couldn't find knobs online so I designed this. The user visible section of the knob is identical to the NAK original but the hidden portion has been simplified to be easy to print. There is a groove molded into the grip to indicate the current position against the scale printed on the front panel.
When printing, be sure the knob is positioned with the round body on the print bed and the finger grip up. No supports should be needed but for the cleanest print I suggest you adjust the seam position to be opposite the indicator groove. I printed mine in grey PLA at 0.08mm layer height for a finish which is very close to the original. I bet a resin print would be perfect. The attached pic exaggerates the differences with original (on right) but sanding will help of course.
I have included two versions of the knob. On my deck the original Nak potentiometers use the "Nak Record Level" knob. It appears the newer Alps pot I used may have rotated the "D" notch 180 degrees, so I created "Nak Output Level" with the indicator groove on the opposite edge. I suggest you print both styles and select the one that orients the indicator slot correctly.
Adding an Output Level Control to the Nakamichi 1.5 (If you are interested)
Disappointingly, the 1.5 model lacks an output level control. Since all models share the same PCB even my machine has the room and the chassis provisions. That's why I designed this knob.
There is a dropdown flap on the front panel of the cassette decks that hides the controls. Two small black screws on the bottom of the deck mount a thin black aluminum bracket with labels for the controls. The bracket is easy to remove once those screws are out and You will need to cut an additional 16mm hole in the aluminum to the left of the "Balance" cutout. Spacing is same as between the current two knobs.
You next need to remove the PCB from the chassis. It is mounted by several screws and the pots are attached to the front panel with locking nuts. Once disassembled You need to remove 2 resistors soldered across the pot connections of the PCB. With resistors gone, solder the pot in place alongside the identical looking pots for "Balance" and "Master" .
When the PCB is reassembled into the chassis the new pot will line up behind your new cutout and one of these knobs should fit perfectly. For your reference, the new potentiometer I found is an Alps/Alpine 10k Ohm Potentiometer, Model RK09712200HA.