1 / 3
HHO cuting gauntry — image 1
1 / 3

HHO cuting gauntry

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a 2 axis flame cutter meant to cut trough metals up to a few mm thick

Rating
0 / 5
Likes
1
Downloads
3
Makes
0
Views
31
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Public Domain

This is is a project meant to use HHO or other oxygen rich fuel mixture to cut metal sheets to any desired shape. There are some hardware parts that you will need, wich you can modify to fit your needs including the series of aluminium extrusions wich i used the 40mm ones becouse i had themlaying around but you can step that down to a 30 or 25 series confortably, the lenght of these extrusions is also something you are in control of the one used for the main frame were 60cm but you can change that to fit you surface area needs, i used NEMA 17 motors but you can also change that as you prefer. Linear guides are also a must, pick  one that doesn't fall though the gap in the middle of the extrusions that way you dont need to drill precise holes, just inserts and then check for alingment across the range of motion, you can use 2gt belts and pulleys, there no need for 1.5gt ones. 

The main constraint for precision is the flame itself so dont worry to much about vibrations and rigidity just make sure you have the highest fuel pressure as you can, pressure is dictaded by the section area of the orifice wich yopu are expelling the fuel so ajust acordingly, my recomendation is to either use 3d printing brass nozzles or MIG tips as these come in many sizes under 1mm as well as being made of thermal conducting metals as well as having a standard thread so you can swap them untill you find the right one for your mass flow rate and fuel, also they have way more thermal capacity than something like a seringe.

There is plenty hardware you will need, most can be changed to what you find cheaper, my list startingwith bolts includes: 12 M4 contersunk 6mm; 3 M4 buttonhead 30mm;51 M3 countersunk 15mm; 12 M3 grub scews; 20 M8 buttonhead 15mm. To mate thith that you will need washers:3 5ID 14OD; 20 10ID 16OD; as well a 3 M4 nuts, also inserts for you chosen extrusion: 27 M3 and 20 M8. Get youself 4 angle brackets around 40mm lenght and around 3 meters of belt, 3 linear rails to the amount of travel you aim for, 3 NEMA 17 steper motors, as well as the drivers for them, this is a 2 part project once i finish building it there will be an update regarding the electronics i will use, you  will need to cut around 32 68x3,5 cm metal sheets wich will serve as a sacrificial replacable part where you rest you parts on, aroung 1mm thick is more than enought if you use reasonable feed rates it should last pretty long.