LMR400 Coax Holder for Transmitting Loop 36.5mm Length
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is for LMR400 or any Coax line that is 10mm diameter. This cable clip holds one loop of coax about 35mm (1.5…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 12
- Makes
- 0
- Views
- 198
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
This is for LMR400 or any Coax line that is 10mm diameter. This cable clip holds one loop of coax about 35mm (1.5 inches) from another loop of coax. It is for a Transmitting Loop Antenna, to add another full loop to lower the frequency of the design loop. It should be printed in PETG. You can print it in PLA, just don't leave it outside as PLA isn't weather proof.
I used Amazon Basics PETG to print this on an Ender 3 Pro:
Nozzle 235-260C (or what your PETG calls for) I used 235-240C.
Bed 80C then after the first layers are sticking you can reduce the bed heat.
I usually run a BRIM.... so that the first layers stick good.
You can use PLA if it's just temporary-Amazon Basics Navy Blue PLA 210 Nozzle/60 Bed, Blue painters tape and glue stick.
.
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/0dietvut0ey
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
.20
Infill:
Cubic
Filament: Amazon Basics PETG Purple (or your choice)
Notes:
This was designed with the Cura Creality Creawesome plugin. https://youtu.be/mOn-VNqg2ac
Use a 12mm Brim for best results.Category: 3D Printing