Trezor Model T Gridfinity Stand & Cable Dock (1×2)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A sculpted Gridfinity 1×2 dock for the Trezor Model T
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 9
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Share Alike
Description
A sculpted Gridfinity 1×2 dock for the Trezor Model T. The original USB-C cable runs fully hidden inside the stand and leaves at the bottom of the back corner. No adapter and no 90° plug needed.
Trezor Model T Gridfinity Stand – Hidden Cable Dock
A clean desk dock for the Trezor Model T. It clicks into any standard Gridfinity baseplate and keeps the cable completely out of sight.
Features
Gridfinity 1×2: standard 42 mm grid, fits any baseplate.
Original cable: uses the straight Trezor Model T USB-C cable. No adapter and no 90° plug.
Hidden cable:
the plug clips into a holder under the Trezor;
the cable snaps into a guide channel inside the base;
it leaves at the bottom of the back-left corner.
Kind to the cable: a gentle internal bend (about 10 mm radius).
The plug doesn't move: a spring tongue, front lips and crush ribs hold it when you dock or undock the Trezor.
Two parts with magnets: lift the cover off at any time to fit or remove the cable. Three pairs of 6 × 2 mm magnets hold it in place.
Comfortable angle: the Trezor leans back so the screen is easy to read and tap.
Magnetic Dock: a pocket for the Trezor Magnetic Dock.
Look and size: ribbed, organic design, only 74 mm tall.
What you need
Printed parts: Base and Cover. The Plug Fit Test is optional.
6 × neodymium disc magnets, 6 × 2 mm (the standard Gridfinity magnet).
A little super glue (CA) or epoxy for the magnets.
Your Trezor Model T and its original USB-C cable.
A Gridfinity baseplate (not included).
Print settings
PLA or PETG.
0.4 mm nozzle, 0.2 mm layers, 3 walls, 15–20 % infill.
Print the Base on its feet and the Cover upright, open side down.
No supports needed: the steepest overhang is about 48°.
Tip: print the Plug Fit Test first (about 15 min) to check that your cable's plug fits snugly.
Assembly
Glue 3 magnets into the base and 3 into the cover. Check that each pair attracts before the glue sets.
Slide the cable into the slot under the plug holder from the front. Push the plug down into the holder until it clicks behind the two lips.
Press the cable into the guide channel so it snaps in. Follow the curve and the left side out to the back corner.
Put the cover on. The magnets pull it into place.
Place the stand at the back edge of your Gridfinity baseplate, so the cable can leave behind it, and dock your Trezor.
Notes
Designed for the original Trezor Model T cable: USB-C plug body about 10 × 14 mm, cable about Ø 3 mm. Cables with a different plug may not fit, so use the fit test.
Gridfinity is an open system by Zack Freedman.
Not affiliated with or endorsed by Trezor / SatoshiLabs. Trezor is a trademark of SatoshiLabs.
