FITTINGS | Male2Male Thread Adapters G 1"–G 2"
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ten male-to-male G (BSPP, ISO 228) reducer adapters, every combination from G 1" to G 2". Prints without supports.
- Rating
- 5 / 5
- Likes
- 29
- Downloads
- 61
- Makes
- 2
- Views
- 278
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Standard Digital File License
Ten male-to-male reducer adapters for G (BSPP, ISO 228) pipe threads, covering every combination from G 1" to G 2". Typical uses are pumps, rain tanks, pond equipment and irrigation lines.
Please don’t scale the parts: the threads follow ISO 228 and are printed 0.2 mm under nominal diameter, so they fit standard female fittings.
These adapters are not compatible with NPT threads.
Have fun!
Also available:
Adapters
Group | Adapter | Wrench size | Height | Bore |
|---|---|---|---|---|
G 1" | G 1 1/4" → G 1" | 50 mm | 62.8 mm | 25.0 mm |
G 1 1/2" → G 1" | 55 mm | 64.0 mm | 25.0 mm | |
G 1 3/4" → G 1" | 60 mm | 65.2 mm | 25.0 mm | |
G 2" → G 1" | 70 mm | 70.5 mm | 25.0 mm | |
G 1 1/4" | G 1 1/2" → G 1 1/4" | 55 mm | 64.0 mm | 33.5 mm |
G 1 3/4" → G 1 1/4" | 60 mm | 65.2 mm | 33.5 mm | |
G 2" → G 1 1/4" | 70 mm | 70.5 mm | 33.5 mm | |
G 1 1/2" | G 1 3/4" → G 1 1/2" | 60 mm | 65.2 mm | 39.5 mm |
G 2" → G 1 1/2" | 70 mm | 70.5 mm | 39.5 mm | |
G 1 3/4" | G 2" → G 1 3/4" | 70 mm | 70.5 mm | 45.5 mm |
Recommended Material
Part | Material |
|---|---|
Adapter | PETG, ASA, ABS |
Print Settings
Setting | Value |
|---|---|
Layer height | 0.15 mm |
Perimeters | 4 |
Top / bottom layers | 5 |
Supports | None |
Infill | 40% or more |
Print Orientation
Part | Orientation on the bed |
|---|---|
Adapter | Upright, large thread down |
Use
Place a flat washer in each female fitting.
Screw the large thread into its fitting by hand until the washer seals.
Screw the small fitting onto the small thread the same way.
If needed, tighten gently with a wrench on the hex. Don’t use thread tape on the end faces; these adapters seal against the washer, not in the thread.
Safety note: Printed adapters are meant for low-pressure water such as pumps, rain tanks and pond equipment. Don’t use them for gas, hot water, drinking-water installations or permanent mains pressure.