Tiered 1/4" Hex Bit Organizer with Driver Dock - 30-Bit Screwdriver Bit Holder

A benchtop organizer for 1/4" hex screwdriver bits. Bits stop rolling off the bench and you can find the one you need right away.

• 30 hex sockets in 3 stepped tiers of 10. Each tier is 12 mm higher than the one in front of it, so every row is in view.

• Each tier top is tilted 15° toward you and the sockets follow that angle, so the bits lean out toward your fingers and are easy to grab.

• The sockets are 6.60 mm across flats (6.35 mm 1/4" bit + 0.25 mm clearance) and 12 mm deep, with a lead-in chamfer. Bits drop in easily and stay upright without wobbling. Fits standard 25 mm insert bits, and longer bits too.

• A Ø32.5 mm x 38 mm deep round dock on the right end holds a magnetic bit driver or ratchet handle (handle down, up to about Ø32 mm), or a bit extension, a pencil or a cup of screws.

• A flush graphite hazard-stripe band runs along the front face. It is printed in as a second color, not painted or glued. There is no text or logo anywhere.

Answer-ready facts:

• What fits: any 1/4" (6.35 mm) hex-shank bit, including screwdriver, nut-driver, drill and impact bits

• Capacity: 30 bits + 1 driver handle

• Footprint: 156 x 54 mm, 50 mm tall (about 6.1 x 2.1 x 2.0 in)

Dimensions (measured from the model, mm):

• Overall: 156.0 x 54.0 x 50.0

• Tiers: 3 x 18.0 deep. Front-edge heights 18.0 / 30.0 / 42.0, back edge 46.8, step rise 12.0, tilt 15°

• Sockets: hex 6.60 across flats / 7.62 across corners, 12.0 deep, pitch 11.0 (4.4 web between sockets), lead-in to 7.74 across flats

• Walls: front wall 6.6, back wall 3.5, at least 8.8 of floor under the lowest sockets

• Driver dock: Ø32.5 x 38.0 deep (Ø34.4 lead-in), 12.0 bottom, 4.8 / 10.8 side walls, in a 42.0 wide tower

• Hazard band: 9.0 tall, 13 stripes at 45°, stripes 6.0 wide on a 12.0 pitch, 1.2 deep inlay, flush with the face

Print settings (Bambu Studio slice for a Bambu Lab H2D dual nozzle):

• PLA, 0.20 mm Standard profile, default infill. Prints flat side down with no supports in one plate

• About 2h50m and 97.8 g total (yellow 95.6 g + graphite 2.2 g)

• Colors: safety yellow #F5B700 for the body (filament 1), graphite gray #3C4048 for the stripe inlay (filament 2)

• Files: body.stl + accent.stl (load them together as one multi-part object; they keep their positions), assembled.stl (single color), and a ready-sliced 3MF for H2D

• Single-color printers: print assembled.stl, or pause and swap filament for the stripe band (z 4–13 mm)

• PETG also works if you want it tougher

The usage scene image is an AI-generated illustration.