1 / 1
Sub250 OasisFly35 TPU Parts
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
TPU parts for the Sub250 Oasisfly35.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 8
- Makes
- 0
- Views
- 146
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
Support is needed:
Around the screw holes on the motor guards
Both ends of the camera cage
The horizontal part in the middle of the antenna mount
The camera cage is printed flat, then wrapped around the original aluminum cage. Good adhesion between print lines is needed, especially for the first layer(s). Consider overextruding and/or raising the temperature a bit.
Also check out my model of the non-printed parts if you want to design your own parts without reaching for the calipers a million times.