2-Inch Riser Feet for Lian Li O11D EVO XL
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bolt-on risers that lift the Lian Li O11D EVO XL 2 in (50.8 mm). They wrap the stock feet. Not yet tested on a case.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 16
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Lifts the Lian Li O11D EVO XL exactly 2 in (50.8 mm) for more room under the bottom fans and easier access underneath. One riser per corner. Each one wraps the stock foot and bolts to the case through the foot's own screw holes, into the case's original thread.
NOT YET TESTED
I designed these against Lian Li's official CAD model of the EVO XL and checked them there: no collisions with any part of the case, and the screws land in the original thread. I haven't installed a set on my own case yet. Print the fit test first and check the fit before trusting them with your build. I'll update this page once I've tested them.
HOW THEY ATTACH
- A socket wraps each leg: 10.7 mm deep, 0.6 mm clearance
- The rubber pad sits in its own pocket, so the leg's hard rim rests on the riser
- Stems go up into the leg's screw holes
- A long screw goes up from underneath, through each stem, into the case's original steel thread
- The front-right riser is open on one side to clear the front I/O module
WHICH FILE -
1 – Fit test (print first): the top of all 4 risers, about 28 mm tall
2 – All 4 risers on one plate: 188 x 163 mm, needs a 200 x 200 mm bed
- Single risers: for smaller beds, or to reprint one corner Built for the standard layout with the I/O module at the front. The front-left leg is the one with a single screw hole.
HARDWARE (not included)
- 7 #6-32 x 1-3/4 in pan head machine screws (M3.5 x 45 mm also works)
- Length matters: 1-1/2 in won't reach the thread, and 2 in is too long. Don't use flat (countersunk) heads.
- #2 Phillips screwdriver, shaft at least 60 mm long and under 8 mm thick
- Optional: 16 rubber bumpers, 1/2 in (12.7 mm) x 3.6 mm, 4 per riser (e.g. 3M Bumpon SJ5312). They add about 2 mm of height.
INSTALL (one end at a time, with a helper)
1. Unplug the PC. Tip the case back so the front feet lift about 10 cm.
2. Remove the original screws from the front legs: 1 in front-left, 2 in front-right. They sit about 28 mm up inside the holes in the rubber pads. The foot bars stay on, held by two more screws in the middle and a clip.
3. Push the risers on: stems into the holes, socket around the leg.
4. Feed a screw up each access hole in the bottom of the riser and tighten until snug. It threads into thin steel, so don't overtighten.
5. Lower the front, tip the case forward and repeat for the rear legs. Keep the original screws in case you ever remove the risers.
Check the fit on your own case before trusting it with your build. Provided as is; you're responsible for your build.