Sink Plug – Tapered or 40×3 O-Ring (PETG, leak-tested)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Two-in-one 3D-printed sink/basin plug with pull tab: tapered press-fit (A) or 40×3 mm O-ring (B). Printed in PETG
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bathroom
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Two versions, one pull-tab plug
A – Tapered: the cone (Ø 49 → 41 mm) wedges into the drain opening. Fits openings of about Ø 42–48 mm.
B – O-ring 40×3 mm: a Ø 41 mm groove holds a standard 40×3 mm O-ring (EPDM or nitrile, not included). Fits openings of about Ø 45–46 mm.
Dimensions (both versions): flange Ø 51 mm × 2 mm, height 13 mm, pull tab 18 mm wide, total length 67.5 mm.
Tested: leak-tested on a Ø 48 mm drain. Measure your drain opening before printing.
Print settings: PETG, 0.20 mm layers, 4 walls, 100% infill, no supports, no brim. Print with the flange flat on the plate. Dry the PETG first (65 °C, 4–6 h) if the spool has been open for a while.
O-ring fitting (version B): stretch the O-ring over the upper part (Ø 44.6 mm) and slide it down into the groove.
Good to know: keep water below about 60 °C. Not food-safe certified. Sealing depends on your drain.
Files: STL and 3MF (Bambu Studio, A1 + PETG) for both versions.
