Break-away BLTouch Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is just for the BLTouch mount that I made for the Hemera Part Cooling Duct by Hangtight. I designed it so it'll…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 194
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This is just for the BLTouch mount that I made for the Hemera Part Cooling Duct by Hangtight. I designed it so it'll bend or break away if it gets snagged by a bad print rather than breaking the BLTouch (which has happened to me unfortunately).
You'll need one 2.5mmx8mm screw to mount it onto the Duct Mount Plate. And two 3mmx6mm screw for the BLTouch.
I've also included the Duct Mount Plate which I only added the screw hole for this mount. You could just use a 2mm or 5/64" drill bit, which is what I did, to create the hole on an existing mount.
These are the offsets you'll need to add to your firmware: X61 Y-31.5
And of course the Z offset will be specific to your setup.
Category: 3D Printer Accessories