1 / 1
Butterfly1 Hueforge
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I created an swallowtail butterfly HueForge.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 2
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- 2D Plates & Logos
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Print with 100% infill and a layer height of 0.08 mm. Set the base layer to 0.16 mm. Filament swap procedure:
Initial filament: Black
Switch to the next filament at layer #8 (0.72 mm): Gray
Switch to the next filament at layer #12 (1.04 mm): Red
Switch to the next filament at layer #16 (1.36 mm): Glossy White (use until the final layer)