Lineair slide bearing for Leapfrog Creatr Y-axis. Uses IGUS GSM-1214-15 bearing sleeves to replace LM12UU
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slide bearing to replace LM12UU linear ball bearings on Leapfrog Creatr. For less noise.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 17
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
LM12UU are round but the space they fit in on a Leapfrog Creatr is square, so these replacements are square. They print in 2 halves. IGUS GSM-1214-15 should fit between 2 of these halves without pinching it against the axle. It should slide freely. (It can help to warm the printed part before fitting the sleeve bearing in it)
When disassembling the leapfrog make sure to put the Y-axis back at the same position / not tilted or slanted (Make sure the block below the axis stays fixed in place, if needed file the alu plate to fit behind the lip). The Y-axis lifts out the top.
If the screws rub on the Y axis, file the screws down on that spot (Same as with LM12UU - screws are too close to the axis).
Dutch blogpost about this: https://www.eluke.nl/2026/11/10/leapfrogs-lineaire-lagers/