1 / 6
LEGO Blue Astronaut 40921 Wall Mount – Floating Display with Screw Covers — image 1
1 / 6

LEGO Blue Astronaut 40921 Wall Mount – Floating Display with Screw Covers

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Compact wall mount for displaying the LEGO Up-Scaled Blue Astronaut upright.

Rating
0 / 5
Likes
1
Downloads
5
Makes
0
Views
36
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Designed for LEGO set 40921, this mount supports the astronaut beneath both feet while providing clearance for the air tanks behind the figure.

The compact platform and shallow underside braces keep the support discreet when viewed from the front. Two recessed screw holes secure the bracket. Matching blue PLA covers fit inside the screw recesses for a flush finish.

Included files

  • Wall mount: compact design with shallow braces, two recessed screw holes and 30.5 mm locating pads.

  • Foot fit test: checks the locating-pad fit before printing the complete mount.

  • 11 mm flush screw cap: fits entirely inside the screw recess without an overlapping cover lip. Print two.

STL and model-only 3MF versions are available.

Dimensions

  • Overall mount: 100 mm wide × 98 mm projection × 94 mm tall

  • Wall plate: 60 mm wide × 94 mm tall × 6 mm thick

  • Platform thickness: 8 mm

  • Maximum underside brace depth: 12 mm

  • Foot locating pads: 30.5 × 30.5 mm, 4 mm high

  • Screw holes: 5.5 mm diameter, spaced 40 mm vertically

  • Screw-head recesses: 11 mm diameter × 2 mm deep

  • Flush caps: 11 mm outside diameter, 0.6 mm face thickness and 1.2 mm total insertion depth

Printing

Designed for blue PLA and a 0.4 mm nozzle. Import at 100% scale in millimetres.

Suggested starting settings for the mount:

  • Layer height: 0.2 mm

  • Wall loops: 6

  • Top and bottom layers: 6

  • Infill: 40%

  • Supports: beneath unsupported areas, depending on orientation

For the foot test, use 0.2 mm layers and 3 walls, with the flat base on the bed.

For the flush screw caps:

  • Layer height: 0.2 mm

  • Wall loops: 3

  • Infill: 100%

  • Supports: off

  • Orientation: flat cover face on the bed, open fitting ring upwards

Print one cap first to check its fit. The 3MF files contain model geometry without configured printer settings.

Fit and assembly

Print the foot test first. The earlier 30.4 mm locating pad fitted successfully; this version increases it slightly to 30.5 mm for a closer fit. The foot rim should sit flat on the test base without force or rocking.

Install the bracket before placing the astronaut. Use screws and wall fixings suitable for the wall construction and projecting load.

The flush caps use friction around the screw recess rather than pegs in the screw heads. Press each cap gently until its face is level with the wall plate. There is no depth stop, so avoid pushing it below the surface.

Screw heads must leave enough clearance behind the caps. If a cap contacts the screw before seating flush, stop rather than forcing it or overtightening the screw. Printed fit varies with printer calibration; the 11 mm caps require a physical fit check.

Tags