Pet/Child lock for IKEA BILLY / OXBERG
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A lock to keep the bookcase from being ransacked by small kids and pets.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 5
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution
IMPORTANT NOTICE - "Safety is number one priority"
THIS "LOCK" DOES NOT REPLACE SUPERVISION!
While designed to be a "lock" this is by no means certified or tested according to any child safety standard. If you are at all hesitant, move on and find commercial products that is certified and fit for purpose.
If you still want to use it, keep safety in mind as it might not even be a challenge for some kids/pets to break.
Avoid brittle materials
Test the strength yourself to see how much force it holds up for before using it.
If it holds up to your expectation consider printing a new one for use as you might have damaged the one you tested.
Using the wrong printing orientation (e.g. printing threads upright) will make it break easily.
Do not make the parts smaller, they are made large to reduce choking hazard if they break apart or are lost.
This "lock" is not ideal if you want to open your bookcase frequently.
Placement should be at a height where it is unreachable. I have used the first bookshelf above the door knobs as it fits badly in between the door knobs.
Possible adjustments needed
Depending on your printer you might need to adjust the tolerances somewhat on the threads.
I have gone for a tight fit rather than a smooth screw for safety reasons.
This design only works if your IKEA BILLY / OXBERG has a large enough gap between the doors. The design thread-pin should fit if the gap is larger than 5.9 mm. If your gap is larger consider making the thread-pin wider for better structural stability.
Screw holes might need adjustemnt depending on the screw size you are using.
Print instructions
I have used the following settings on Core One L with good results
Layer height: 0.15 mm structural
Nozzle: 0.4 mm
Infill: 25% Gyroid
Filament: PETG - avoid brittle filaments
Orientation - main part: On its side, supports everywhere
Orientation - nut: flat side on bed, no supports
Brim: No
