1 / 2
Bonn Mounts for Steam Frame (Babble / VFT / VIVE Facial Tracker / Face Tracking + Arcturus Vision Camera) — image 1
1 / 2

Bonn Mounts for Steam Frame (Babble / VFT / VIVE Facial Tracker / Face Tracking + Arcturus Vision Camera)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Two-piece mounting system for Steam Frame & front-mounted accessories. Supports Arcturus Vision Camera & Stock configs!

Rating
0 / 5
Likes
1
Downloads
30
Makes
0
Views
195
Reviews
0

Updated at source:

Model information

License
GNU General Public License v3.0

Installation & removal

  • Align the top of the mount with the vent holes, in the top-middle of the headset

  • Insert into the vent holes all the way

  • Push the opposite end of the mount towards the headset - it should snap into place

To remove:

  • Start at the bottom of the headset

  • Pull the bottom of the mount up, as if opening a can with a ring-pull

  • If you struggle with this, use a plastic pry tool to assist

  • It will lift off without issue

The fit is expected to be "snug, not tight".

It should not be difficult to install the mount - if you use excessive force and achieve an extremely tight snap fit, you will likely need to cut the mount to remove it! Ask me how I know.

Removing the mount may feel "too easy", but bear in mind that the accessory mounting point isn't anywhere near the bottom of the mount. It holds better than you'd think!

Installing an Accessory

It's a dovetail fit, so just slide it in place and push down firmly.
It'll hold better than you might expect!

To remove, grip the sides of the mount base with two fingers, then with a third, use the top of the headset to pull the accessory straight up out of the slot.

Printing

  • 0.2mm layer height

  • 0.4mm nozzle

  • 3 perimeters

  • 12% Gyroid infill

  • ⚠ Paint-on support enforcers ⚠

    • Check the guide!

  • PETG, or some other creep-resistant material is advised

  • File/sand the supported dovetail surfaces post-print to improve the fit

Tolerances are baked in and tuned for 0.2mm separation - any well-tuned or modern printer should be able to print these such that they fit snugly.

If you have fit issues, consider adjusting the extrusion width or multiplier rather than the scale; particularly for the stock Steam Frame mount.

Mounts

  • Use organic or tree supports, so the dovetail slot is properly supported

Accessories (Base & VFT)

  • Standard "snug" supports work fine here

Why "Bonn"?

It's a single-syllable word that groups together compatible parts in a hopefully non-confusing way.

Tags