1:20.3 scale (fn3) Rio Grande High Side Gondola
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a model of a narrow gauge Rio Grande High Side Gondola in 1:20.3 (Fn3) scale.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 29
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I've printed versions of this car with ASA and PLA using an Elegoo Centauri Carbon. .4nozzle. I first assembled the frame pieces, gluing them together using Gorilla Glue epoxy and using the support beam (one of the STLs) along the outer most sides of the undercarriage for additional support (glued in place). I used some plastic putty in the frame seams as well as the top of the coupler box and sanded smooth. I then sprayed all pieces with rattle can Tamiya Grey Primer. I then sprayed all parts with rattle can Tamiya TS33 Dull Red. I assembled the panels onto the frame, using a little bit of epoxy again to secure in place. I used 3mmx7mmx3mm roller bearings off of Amazon for the trucks, popping them in place (I've had to drill the hole slightly to enlarge a bit if you are not able to pop them in). I ended up using a washer between the frame and the truck to reduce friction, and 3mm screw and washer to secure truck in place. If using the truck crossbar version for the Accucraft wheels, you'll need to drill out the hole of the truck crossbar with a 1/4" drill bit. I used Kadee 835 couplers and 1/16" brass rods for the truss. The two outer rods I just fit to length along the sides, but the two center rods I drilled holes to secure in the frame. See pictures. Enjoy this print! It's not 100% perfect to prototype, but it is a great representation.