GPU Vertical Twice Mount Bracket Base
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple yet poweful and versatile gpu mount bracket to make you GPU stand upright [twice].
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 78
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
GPU Vertical Twice
A simple model to make you GPU look awesome!
Right now it doesn't fit a HDMI or DisplayPort cable it is mostly for headless gpus, maybe later I will try to add a way to make attaching a cable possible without making it look terrible.
The big suprise are the temps, making it stand upright take the most out of the vapor chamber or two-phase heat pipes so THE TEMPS ARE EXTRAORDINARILY LOW. On the RTX 3080 Legion that I tested temps were almost 10 degrees lower.
You must use a M3 screw 25mm or longer to screw the PCIe plate in place, also there's room for an optional threaded insert.
Printing Tips
Base
The base is best printed in a material with minimum creep/sag and good heat resistance.
I recommend ABS or PETG. PC and PPS are also good but more expensive. Avoid PLA for the reasons mentioned above.
Layer Height: 0.16 mm
Wall Generator: Arachne
Walls Printing Order: Inner/Outer/Inner
Precise wall: ON
Bridge Flow Ratio: 1.5
Thick Internal Bridges: OFF
Bottom Shell Layers: 5
Wall Loops: 3 or more
Infill: Grid
Infill density: 11%
Speed
Bridge External: 20 mm/s
Bridge Internal: 75 mm/s
Pads
The pads are best printed in TPU 90 or 95.
Use the standard settings, there's nothing fancy about it.