1 / 5
AxiDraw XL Dovetail Pen Holder for 1 Inch Barrels — image 1
1 / 5

AxiDraw XL Dovetail Pen Holder for 1 Inch Barrels

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Two-piece AxiDraw pen holder for round barrels up to 25.4 mm, with a sliding dovetail, captive M3 nuts, and a fit gauge.

Rating
0 / 5
Likes
2
Downloads
2
Makes
0
Views
17
Reviews
0

Updated at source:

Model information

License
Open Community License v1.1 + Micro Business v1

This two-piece pen holder is designed for round pen and marker barrels from 12 to 25.4 mm (up to 1 inch). Two V-shaped saddles support the barrel. The clamp arm slides into a dovetail and locks with one screw. A standard M3 hex nut in the arm provides the threads for the pen thumbscrew.

Compatibility

Designed for an AxiDraw carriage with two M3 mounting holes spaced 31.75 mm center to center. The plate has hole pairs for upright and 45° mounting. The gauge fit was confirmed on one AxiDraw carriage. Print the gauge first to check yours. Inspired by the factory XL clip. [Original AxiDraw XL pen clip](https://shop.evilmadscientist.com/productsmenu/907)

Bill of materials

  • 1: Printed dovetail mounting plate 

  • 1: Printed dovetail clamp arm

  • 1: Socket-head cap screw M3 × 0.5 thread, 10 mm long under the head.
    Locks the dovetail. 

  • 2: Standard hex nuts M3 × 0.5, about 5.5 mm across flats and 2.4 mm thick.
    One in the plate and one in the arm. 

  • 1: Nylon thumbscrew M3 × 0.5 thread, 25 mm long under the head.
    Clamps the pen. 

  • 2: Stock AxiDraw button-head screws
    M3 × 8 mm on the reference carriage. Reuse these to mount the holder. 

  • 1 optional: Printed mounting gauge
    A separate fit check.
    Remove it before installing the holder. 

Printing and assembly

1. Print the gauge and check that it sits flush and both stock screws start by hand in your intended orientation.

2. Print the plate with its flat carriage face down. Print the arm on its broad side with the nut slot facing up. The STLs are supplied in those orientations. Clear any stray plastic from the dovetail, nut pockets, and screw holes.

3. Seat one M3 nut in the recess on the back of the plate. Slide the arm into the open end of the dovetail until the lock screw holes line up. Install the M3 × 10 screw before mounting the assembly.

4. Slide the other M3 nut into the arm’s side slot and engage the nylon thumbscrew. Mount the holder with the stock button-head screws. Set the pen height and tighten the thumbscrew gently.

Check pen position and travel

A successful gauge fit confirms the mounting pattern on your machine. Check the tip position at Home, pen-up and pen-down clearance, and usable drawing bounds with the assembled holder and the actual pen installed. The tip can land in a different place from the stock setup, and the larger clip, screw, or barrel can limit travel near the edges. Align your paper or artwork to the new tip position and keep the entire job, including pen-up moves and the return to Home, within the clearance you verified. [AxiDraw setup guide](https://cdn.evilmadscientist.com/dl/ad/public/AxiDraw_Guide_v571.pdf)

Tags