1 / 2
Cleaning bottle level guide for QuidelOrtho Vision analysers — image 1
1 / 2

Cleaning bottle level guide for QuidelOrtho Vision analysers

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A guide to quickly show the maximum fill level for the cleaning bottles for QuidelOrtho Vision analysers.

Rating
0 / 5
Likes
0
Downloads
0
Makes
0
Views
5
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

A guide to quickly show the maximum fill level for the 10ml and 50ml sodium hydroxide (NaOH) cleaning bottles for QuidelOrtho Vision and Vision Swift analysers.

Please note that I strongly recommend that this is printed in ASA, as it will be in close proximity to corrosive liquids, so should be post-processed after printing to ensure nothing can soak in the cracks between extrusion lines. As ASA is soluble in acetone, this can be easily done by allowing it to sit in a vapour chamber filled with acetone, which will gently melt the surface filament and fuse all of the gaps (method described below).

Two files are provided: A 3MF file set up for multimaterial text printing, and an STL file with the text embossed for single extruder printers.

Vapour chamber setup

A simple way to set up a vapour chamber is to place the printed cover on woven or perforated metal mesh bent on the edges to make it a slightly raised platform (place the part lettering up, as the mesh will leave a slight imprint on the bottom of whatever rests on it), such that both will fit comfortable inside a sealable polypropylene food container.

Ensure this is done in a well-ventilated area like an open garage to avoid persisting fumes. Before placing anything in the container, acetone should fill the container to a level somewhere below the top of the raised mesh platform. The platform is then placed in, and the plastic part placed on the platform afterwards. A strip of absorbent material like kitchen roll can be placed inside to increase the evaporation surface area up the walls, as long as it is not allowed to make contact with the plastic part which will damage its surface. The lid should then be sealed on three corners only, which will prevent the majority of the acetone vapour from escaping without building up pressure inside the container. After about 30 minutes, carefully remove the lid (to avoid splashing acetone around), remove the platform (avoiding touching the wet plastic as this will leave fingerprint blemishes), and allow the acetone on the surface to evaporate for 5 to 10 minutes. Layer lines may appear evident while wet, but these should smooth out somewhat as it dries. The remaining acetone in the chamber should be relatively free from plastic contamination, so it can be poured back into the original container for future vapour chamber use (though I would not recommend using it for other purposes that call for pure uncontaminated acetone).