Mictrack MT710 Collar Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Slim one-piece TPU holder for Mictrack MT710 GPS tracker on 20 mm collars – clamps tight, no wobble, charge in place.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 1
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Public Domain
Slim one-piece TPU holder for the Mictrack MT710 GPS tracker, designed for a 20 mm collar or harness strap and much more compact than the original silicone case.
The strap runs over the tracker's back and dips under two end bridges with strap-wide grooves, so under tension it clamps the holder firmly with no wobble, while the curved back follows the neck.
Installation: first thread the strap, buckle included, through both bridges of the empty holder, since there is plenty of room without the tracker inside.
Then press the tracker in from the back, underneath the strap, until it snaps behind the side lips, and pull both strap ends to seat the strap in the grooves.
Print in TPU 95A with the front face on the bed and supports only under the bridges; the magnetic charging cable still fits while mounted.