Splash Guard for Breville/Sage Bambino Plus Espresso Machine 3-way Valve Outlet
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A small splash guard to reduce leakage under the drip tray, especially when performing the cleaning cycle.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 12
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
Leakage of water under the Bambino Plus espresso machine drip tray is a very common problem with three contributing causes: incomplete tray insertion, steam wand purging spray and overflow of the small tray section at the rear left of the drip tray where the 3-way valve dumps pump pressure. This splash guard tries to address the last cause.
The volume and force of the water and steam that gets dumped into that small tray section can easily overwhelm its ability to drain, resulting in quite a bit of water splashing over the sides and collecting under the drip tray. This splash guard helps contain that release and improves on the ability of the drip tray to direct it towards the main section of the drip tray. The rear of the splash guard wraps around the 3-way valve outlet tube and the front edge of the guard fits nicely under the drip tray grill.
If you run the cycle with the cleaning disk in for awhile or you use the two-shot basket for cleaning, the volume of the release is really vigorous and you may still see a little dripping. I've seen a huge reduction with this splash guard though.
Probably best to print from PETG or ABS/ASA. Even though this part really isn't under any significant mechanical load, it does see very hot water and steam for a few seconds and PLA might warp quite badly.