Sutrah (Prayer Barrier) - Geometric Lattice Arch Panel with Base
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Freestanding 47 cm sutrah for salah with an Islamic geometric lattice. Prints in two halves on a 256 mm bed.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 12
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A sutrah is an object placed in front of a person performing salah to mark the edge of their prayer space, so that others know not to walk directly in front of them. This one is a freestanding pointed-arch panel filled with an Islamic geometric star lattice, standing in a stepped base. It works well at home, in an office prayer corner, at school or in the masjid.
Dimensions
Panel: 119 x 10 x 450 mm
Base: 250 x 120 x 30 mm, with a 117 x 10 mm slot about 9 mm deep
Assembled height: about 471 mm (18.5 in)
Files
sutrah_lattice_cut_for_256_bed.3mf: ready-to-print project. The panel is already cut into an upper and lower half with two dowel pins, laid out on four plates (dowels, base, upper half, lower half). Use this if your bed is around 256 x 256 mm.
sutrah_lattice_panel_full.stl: the full uncut panel, for large-format printers or if you want to make your own cut.
sutrah_base.stl: the base.
Print settings
Printer used: Elegoo Centauri Carbon, 0.4 mm nozzle, textured PEI plate
Material: PETG (Elegoo Rapid PETG), 250 °C nozzle, 70 °C bed. PLA also works for indoor use.
Layer height: 0.2 mm
Walls: 2, top and bottom layers: 2
Infill: 5 % rectilinear
Supports: none. Print the panel halves lying flat and the base flat side down.
Brim: 5 mm outer brim on the panel halves helps the long thin parts stay flat
Print time on my printer: about 6 h 48 min for the panel and 2 h 18 min for the base
Assembly
Print the two panel halves, the two dowel pins and the base.
Remove the brim and clean up the cut faces.
Press the two dowel pins into the holes of one half. Add a drop of super glue or PETG-safe glue if you want a permanent joint.
Push the other half onto the dowels until the cut faces meet and the lattice lines up.
Slide the bottom edge of the panel into the slot in the base. It is a snug fit, so it can be left unglued for flat storage and transport.
Notes
If the dowels are too tight, sand them lightly or scale them down 2 to 3 % in X and Y.
The same base fits my open arch frame sutrah.
The cover image is a render of the assembled model.