1 / 6
RC Autoscooter, Ihle ES-SG 1:5 — image 1
1 / 6

RC Autoscooter, Ihle ES-SG 1:5

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

RC Autoscooter, Ihle ES-SG 1:5

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
13
Reviews
0

Updated at source:

Model information

Category
Vehicles
License
Creative Commons — Attribution — Noncommercial — NoDerivatives

The goal of this project was a simple model of an Autoscooter which drives like a real autoscooter. With 360 degrees steering. After a long time tinkering here is a working prototype.

The chassis is based on a 3d scan of my Ihle ES-SG that sits in my Living room.

The tire works great when printed in TPU. The Lights are printed with translucent PETG. Everything else is printed in PLA.

For the backwheels i used a nail as joint. Glued it down with some 3d Filament and a soldering iron. Since the are just dragged along, they can be printed in PLA.

Video:

Parts needed:

2 Micromotors (square part: 9mm, Long round part: 15mm)

https://www.amazon.de/dp/B0CJY4VPD6?th=1

Use a Motor with more RPM if you want it to go faster. I am not an expert on that. i tried out the ones i had lying around and i like it so far. Maybe i'll swap it out for a faster one.

and a Controller for the 2 dc motors

1 USB Magnet cable, for the Spinning cable joint

https://www.amazon.de/dp/B09P393M16?th=1

1 Micro USB Breakout board (where the board is: 14mm wide, 15mm tall)

Plastic Gear Set for 2mm Motors

https://www.amazon.de/26Pcs-Plastic-Gear-Motors-Robot/dp/B0HGM4CLW9?__mk_de_DE=%C3%85M%C3%85%C5%BD%C3%95%C3%91&crid=2J7OWCG7PIN5Q&dib=eyJ2IjoiMSJ9.x8nVSv7YwW7F7ozoTmHPwntmK2jsRSbrdM-OUHZ6dD09cK_ZQUn9l-q-Um2oOXbCNbiT4WSF1UkeLyAnffNH_w4sdjc_DOgsfRd-UtTj7gQ2d_jWgeh1GdtMea2ESCuR4kVxwfUZmBJQTzoZeONJKHsFMbXXvpQ6YfFOlYDiCYuEaUwffXt2w301wpScpqltAFqrgOOb_QQSGztkFqrqBA.bFEgLroy2JdYYV53euMquiPR89NiAYddaOL_q8wMFwY&dib_tag=se&keywords=micromotor+gear+set&qid=1791198708&sprefix=micromotor+gear+set%2Caps%2C117&sr=8-7

For the Lights i used a Teensy and some RGB Neopixels and hooked it up to the battery pack.

2 nails for the backwheels

Tags