Kit Card Dump Truck - Snap-Fit Toy, Tipping Bed, No Supports
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
One flat print: snap out the parts and build a dump truck with a tipping bed and rolling wheels. No glue, no supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 2
- Makes
- 0
- Views
- 14
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution — NoDerivatives
A dump truck kit card: print one flat card, snap out the parts, and build a little dump truck whose bed really tips up on a hinge pin and whose wheels really roll. No glue, no screws, no supports.
Why it's fun: it prints in about an hour, it's a great 5-minute build for kids (and adults), and the tipping bed makes it an actual working toy rather than just a model. It also makes a nice gift or desk toy.
Parts on the card (17): 2 chassis/cab sides, 1 grille with bumper, 1 cross member, 1 cab roof, 2 bed sides, 1 bed floor, 1 tailgate, 1 headboard, 4 wheels, 2 axles, 1 hinge pin.
Card size: about 113 x 71 x 2.5 mm. Assembled truck: about 51 mm long, 27 mm wide, 23 mm tall.
Assembly
Step 1: Snap all the parts off the card and clean up the small gate nubs with a fingernail, a file or a hobby knife.
Step 2: Hold the two chassis sides upright, cab ends at the front. Slide the cross member down into the middle slots and the grille down into the front slots (bumper at the bottom). The slots interlock like an egg crate.
Step 3: Drop the roof onto the top of the cab so its tabs sit in the notches.
Step 4: Snap the two axles up into the round slots at the bottom of the chassis, then press a wheel onto each end of each axle. The square holes grip the axles and the axles spin in the slots.
Step 5: Build the bed: lay the floor down, fit the two bed sides so the floor tabs sit in the notches along their bottom edges, then slide the headboard (taller wall) into the front slots and the tailgate into the rear slots.
Step 6: Push the hinge pin into the round slot at the back of the chassis, then snap the hooks at the back of the bed onto both ends of the pin. Lift the front of the bed and it tips like a real dump truck.
Print settings
PLA, 0.2 mm layers, 3 walls / perimeters, 15-20% infill, no supports. A brim is optional (helps if your first layer is a bit loose). Print time is roughly 1 hour depending on your printer. If the joints are too tight or too loose, try scaling the card by 1-2% or adjusting flow; the slots are designed with 0.15 mm clearance for 2.5 mm parts.
If you print one, please post a Make with a photo, I'd love to see your dump truck. Check out my other kit cards too, there's a whole collection of vehicles to build.
