Pillory - Briar - League of Legends
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Briar Pillory from League of Legends, designed for my partner for a cosplay a few years ago.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 9
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Cosplay & Costumes in general
- License
- Creative Commons — Attribution — Noncommercial
My partner needed a pillory for her Briar cosplay a few years ago, and as such, I modelled this in OnShape for her.
This was printed in multiple pieces, you'll need to cut it up as needed on your side to allow each side of the pillory to fit.
I left some room inside for 2 rods, which join through the center piece, to add a bit of support around the joining pieces.
I recommend adding extra walls and infill for strength and to print with supports as needed.
Some of the technical details:
Width: 1345mm (Spike to spike)
Height: 723mm
Depth: 171mm
Hand Holes: 66mm (Room for thumb, but this is tight)
Rod Thickness: 8mm
Rod Length: 200mm (One is slightly shorter, cut to length)
Step files included for good measure!
The pieces are glued together and then plastic welded all around the seams. Sanded down, filled with more filament and wood filler, and sanded again, repeat until smooth.
This weighed in at just over 4KG, but it probably should have been heavier, we could have added more walls. It's hard to wear, bear in mind!
Originally, I wanted to leave spaces internally for electronics, lighting, and storage, but crunch meant this version is mostly solid, and some pieces may feel like they would have had more.
If you want to see the cosplay in action, or others check out @coolcaplee on socials!