1 / 3
Knitted Mitten Gift Card & Cash Holder - No AMS, No Supports, No Glue — image 1
1 / 3

Knitted Mitten Gift Card & Cash Holder - No AMS, No Supports, No Glue

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Knitted-look mitten that hides a gift card or banknote. Hang it on the tree. One filament change gives the white cuff.

Rating
0 / 5
Likes
0
Downloads
3
Makes
0
Views
15
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

IMPORTANT: PRINT IT STANDING UPRIGHT (VERTICAL), ON THE CUFF, exactly as the files are exported. The colour change at 22 mm only works in this orientation: start with white filament and change to the mitten colour at 22 mm (the top of the cuff) to get the white cuff. If you lay the mitten flat on the bed, you will not get a white cuff, and the knit texture and the hidden pocket will not print correctly.

The coziest way to give a gift card or a bit of cash this Christmas! This mitten has a real knitted look (stockinette stitches on both sides and a ribbed cuff), and a hidden pocket inside that holds a standard gift card (85.6 x 54 mm) or a folded banknote. The card peeks out of the cuff just enough to pull it out.

  • Hidden pocket for a gift card, a folded banknote, a voucher or a handwritten note.

  • Hangs on the Christmas tree: thread a ribbon through the two small holes in the cuff.

  • Left and right versions, so you can make a matching pair (one for each kid, or a his & hers gift).

  • No AMS needed: pause at the top of the cuff (22 mm) and swap to your mitten colour (white cuff + red, green or any colour). This only works if you print the mitten standing upright.

  • No supports, no glue, no assembly. It prints standing on its cuff.

  • Size: about 88 x 17 x 118 mm (width x thickness x height). Cuff height: 22 mm.

  • Parametric .scad file included: pocket size, how far the card sticks out, mitten size, thickness, cuff height and stitch size.

All photos are real prints made on my Creality Ender 3 V3 KE.

PRINT SETTINGS

  • Material: PLA

  • Layer height: 0.2 mm

  • Infill: 10-15 %

  • Supports: none

  • Brim: 5 mm recommended

  • Orientation: standing upright on the cuff; colour change at 22 mm

Tags