Xshot Spinshot (Break Barrel) Belt-Fed Conversion
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This converts the Breakbarrel into a belt-fed model for more capacity.
- Rating
- 5 / 5
- Likes
- 6
- Downloads
- 3
- Makes
- 1
- Views
- 43
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Public Domain
UPDATE November 13 2026
Increased rotator front end radius from 6.75 to 6.9mm and added file to listing
This is my first blaster model! I'm quite surprised at how well the belt feeds, I had very few, if any, malfunctions while I was testing the model. That being said, I didn't run it super hard so there may still be issues, largely with the shell not aligning with the barrel and air tube.
In the images, I have a 12-shell belt, but please note this is not long enough to take on and off of the blaster without removing one of the filament hinges! I ran out of filament to print with but my guess is that you'd need 14-16 shells on a belt in total to slip it on and off of the blaster nicely.
Please also note that the longer the belt is, the heavier it is, and the weight may cause the belt to not rotate correctly, though this is also untested.
I did find in my testing that using a belt that was not joined to itself (ie the belt didn't loop) the shells didn't feed very well at all.
Print Instructions
Print 1 of the Rotators, and as many of the Belt pieces as you'd like - the items are pre-oriented and designed to be printed with no supports. The belt shells are then put together using a piece of filament. The Belt Shells are designed in a way that the side that touches the build plate is the side that interfaces with the barrel. You should notice the other side is wider, and interfaces better with the plunger tube side.
You can likely use standard print settings for both of these items, I printed these with 3 walls and 15% infill, and I haven't had an issue yet!
