1 / 6
Thumb Knob for Blazer Big Shot GT8000 — image 1
1 / 6

Thumb Knob for Blazer Big Shot GT8000

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Customize your torch and make it easier to use

Rating
0 / 5
Likes
0
Downloads
2
Makes
0
Views
12
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial

I made this cap for the gas valve on a Blazer GT8000 for improved control and ease of use. The lever on the side enables your thumb to open the valve then click the ignition. In addition to the thumb stud, it features long raised bumps that further improve control compared the original valve. It seats with a satisfying snap and will stay on your torch even during transportation. It is possible (but not easy) to remove by gently wiggling it back and forth and pulling away from the torch.

Print it in a fun color to customize your torch!

Features:

  • Improves control of the gas valve

  • Blocks the ignition switch when closed

  • Enables one handed operation (not recommended)

  • Grip bumps for control

  • Clicks over the existing valve cap and stays put

  • No torch modifications needed

Printing Instructions:

  • Print with the thumb lever on the build plate

  • Clean your build plate and go slow for the first layer (20-30mm/s)

  • Supports are required

  • Any filament will do, I used PLA

  • Any print height works - tested with 0.1mm and 0.2mm

  • 2 perimeters and 15% rectilinear infill is plenty

Installation Instructions:

  1. Turn the gas valve to the off position and tighten gently

  2. Position the new cap over the gas valve with the thumb stud over the ignition switch

  3. Fully insert the cap onto the gas valve until it clicks

Tags