Sabot for shooting .585 balls from a CAL-12 rifle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Sabot for shooting .585 balls from a CAL-12 rifle
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 39
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Open Community License v1.1
This is a sabot for shooting .585 balls from a CAL-12 rifle. It fits the choke because of the tiny drive bands which fall of at the choke.
I use leftover pieces of PETG and PLA to make these. When shooting with blackpowder its advised to use a hardcard or cork layer between the sabot and the powder to avoid melted plastic in the barrel. For nitro powder us a plastic separator.
You need to print 3 for each cartridge. Freecad file is included in case you want to change anything.
WARNING: Always test and measure projectiles before you shoot anything. I tested everything very well but not all 3D printers and materials are the same, just be careful. I dont take any responsibility if something goes wrong.