1 / 4
Mankati Full Scale XT - E3Dv6 / Vulcano mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
"To attach the two printed parts i've designed it to use 2 m3x10mm hex cap screws. The holes should be just small…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 12
- Makes
- 0
- Views
- 154
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
"To attach the two printed parts i've designed it to use 2 m3x10mm hex cap screws. The holes should be just small enough that the screws can self tap. So please don't over tighten."
-The original designer-
The ultimaker and Mankati Fullscale XT are almost the same so with a little adjustment on the axle spacing it is useable on the Mankati Fullscale XT.
- Print this, all models are to be printed without support
- Disassemble your printhead
- Remove red block
- Put on mount
- Add your E3D v6 or vulcano head.
- Add clamp
- Add fanduct or fanduct BLtouch if you installed a BLtouch
Category: 3D Printers