1 / 1
Tower of Terror - Elevator Indicator
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These models will allow you to create a replica of the Tower of Terror Elevator Indicator
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 116
- Makes
- 1
- Views
- 1,052
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Art & Designs
- License
- Creative Commons — Attribution — Noncommercial
This are the models for the hand of the Tower of Terror Elevator Indicator. I did not make the original models, they were made by HRJunior on Thingiverse. I have made some changes, such as…
- Reduced geometry complexity
- Cut some sections to make them easier to print
- Cut some sections to fit smaller beds
Printing this took roughly an entire spool.
You can adjust the infill on most parts to suite you and your print times. I wouldn't go lower than 10% on the back plates as you'll run the risk of holes if you do.