DaVinci 1.0A Wire-Brush Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Update 2: Angled the nest for the brush by another 10° (20° total) for better cleaning action. I'm no longer sure…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 4
- Makes
- 0
- Views
- 130
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
Update 2: Angled the nest for the brush by another 10° (20° total) for better cleaning action.
I'm no longer sure where I saw the idea for this, but this one is modified for my preferences. It was made to hold part of a wooden, Harbor Freight, brass wire brush that now seems to be gone.
This looks like it may be close... https://www.harborfreight.com/2-pc-welding-brush-set-63514.html
The original brush was just under 1/2" wide.
Cut a 1" section off of the end and insert into holder. Remove the stock, nozzle-wiper assembly and replace it with this.
I also cut down some of the bristles in the middle so that the nozzle would not touch them when parked.
Update: I just found my spare brush and it's a Lincoln Electric KH582.
https://www.homedepot.com/p/Lincoln-Electric-Wooden-Handled-Brass-Wire-Brush-KH582/100341127
https://www.lowes.com/pd/Lincoln-Electric-Wire-Brush/999971568
I also added some holes so that you can use a small screw to hold the brush in if it's not tight enough, or if you cut it a bit short.
Print Settings
Rafts:
No
Supports:
Yes
Category: 3D Printer Accessories