Diatone MXC Taycan rear GPS mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple rear shelf designed to fit the BrainFPV GPS module. Will also fit the uBlox M8 GPS and most other drone-sized…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 18
- Makes
- 0
- Views
- 211
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
A simple rear shelf designed to fit the BrainFPV GPS module. Will also fit the uBlox M8 GPS and most other drone-sized modules.
Tip: In addition to VHB tape, use a heat gun to warm up the tabs and then form them against or over the edges of the GPS module for a very secure fit.
There is a gap in the shelf supports that allows you to attach a small module such as a receiver or Vifly Finder/Beacon using VHB and a zip tie.
Print Settings
Printer:
Flux Delta
Rafts:
No
Supports:
Yes
Resolution:
0.18
Infill:
No, 5 outer wall rings.
Filament:
AmazonBasics PLA
Black
Notes:
You'll be printing on supports no matter what, so align the print plane to the camera base plate or to aircraft level.
Category: R/C Vehicles