Fan Backwash eliminator and finger guard for Ormerod hot end
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The fan on the Ormerod hot end produces a lot of backwash. This backwash eliminator is based on a design by kwikius…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 14
- Makes
- 0
- Views
- 142
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
The fan on the Ormerod hot end produces a lot of backwash. This backwash eliminator is based on a design by kwikius (Andy), which I have modified to make it thin enough to allow the hot end to slide behind the Duet enclosure on the Ormerod 1. It is held in place by 50mm countersunk screws instead of the original clips. You can either use just 2 screws (which replace the original 2 screws used to hold the fan, heatsink block, heatsink and plastic parts together), or you can drill 2 more holes in the heatsink and use 4 screws, with nyloc nuts on the ends of the upper 2 screws..
Category: 3D Printer Parts