1 / 2
9.5mm Square Hole M5 Screw Insert (License Plate, etc, inc Fiat/Subaru/Toyota) — image 1
1 / 2

9.5mm Square Hole M5 Screw Insert (License Plate, etc, inc Fiat/Subaru/Toyota)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement for the license plate plastic or rubber-and-nut found on many cars. Has print in place supports.

Rating
5 / 5
Likes
23
Downloads
252
Makes
2
Views
1,188
Reviews
1

Updated at source:

Model information

Category
Automotive
License
Creative Commons — Attribution

The license plate on my new-to-me Fiat 500e was missing the inserts for the lower bolts that retain the plate.

The holes were 9.5mm square and I didn't have any square bolts. Instead I made these inserts.

Print as loaded, no supports. I print two at a time to keep them from overheating as it's pretty small.

After printing, break off the support (there's a handy flat spot that prints on the bed).

Then get one side in the hole, push good and hard to the side and then in, and with a decent POP, in it goes.

I was able to drive M5 bolts directly into these without issue.

I printed mine in PETg but imagine other materials would work. If it's too tight, take a tiny bit of horizontal expansion out or scale a few percent. I wanted a snug fit, so I print as is and push harder to install.

Category: Automotive

Tags