Support test
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made this after remixing the all in one 3D printer test (/thing:3718940) because I realized I didn't want to do a…
- Rating
- 4.971 / 5
- Likes
- 457
- Downloads
- 26,430
- Makes
- 39
- Views
- 45,142
- Reviews
- 34
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I made this after remixing the all in one 3D printer test (/thing:3718940) because I realized I didn't want to do a full 8 hour print just to see if I was making improvements on my support settings.
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
100%
Filament: Sunlu PLA Plus Orange
Notes:
This is a small model at 10 x 22 x 20 and doesn't take too long to print. It will test supports attached to the build plate as well as supports that are sitting on top of your model.
In Cura, I used a 15% support density in zigzag pattern. I also enabled support interface and used 1mm floor/roof thickness, grid pattern at 30% density. For this print at 0.2mm resolution, the bottom Z distance is 0.4 mm while the top Z distance is 0.2. The floor breaks away rather easily from the model and leaves hardly any marks; The roof is a bit harder to remove, but leaves pretty good surface quality on the underside of the supported overhang. I'll still probably drop the interface density down to 20 or 15% and see if it makes any difference to the ease of removal, or reduces overhang quality.Category: 3D Printing Tests