Led Support HK Fabrikator Mini 2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This led support suits the HK fabrikator mini 2. I used this device https://www.banggood.com/Remote-Controller-11Keys-…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 7
- Makes
- 0
- Views
- 150
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This led support suits the HK fabrikator mini 2. I used this device https://www.banggood.com/Remote-Controller-11Keys-Mini-Dimmer-for-Led-Single-Color-Strip-DC-12V-p-91895.html?rmmds=myorder for remote control of 3 leds on each side of the printer
Print Settings
Printer:
fabrikator mini 2
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
10%
Post-Printing
location of wires where to solder input of led controler.
Ground wire (black) is solder on the main plug of the board (easy to remove the plug and the cable to solder on top)
12V wire is solder on the main 12V from the back of the switch. Thus i don't need to switch on the printer to get the led on, i can control the led without switching on the printer. Again easy access to the wire, no cut needed.
Red and black wires soldered to the input of led controler
soldering cables from the output of led controler to both led support.
Soldering instructions
Solder the input of led controler to the black wire (taken on the plug of the card) and the red wire (taken on the switch. You can easily remove both wires to solder a cable here and then put them back in place (no need to cut any wire).
Then solder black and red onto the same cable for both the 2 leds supports as shown on the draw.
Category: 3D Printer Accessories