Rhombagon Spiral - Large Plant Pot
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€18.68 – €22.83 net (excluding VAT)
For file: Pot II_0.2mm_PETG_MK3S_21h21m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €20.75 excluding VAT (range midpoint).
- Weight reported by the author
- 265 g
- Print time reported by the author
- 21.35 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
A hybrid of my previous two plant pots, with even more details!
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 78
- Makes
- 0
- Views
- 686
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Need a plant pot that barely fits the print bed? No Problem!
Don't like the size? Scale it down (or up if you wish) to suit your needs.
There are two parts to this, the pot (for your plant to sit in), and the frame (for your pot to sit in). While the frame is mostly for style and is not essential to print, the pot does have holes in the bottom to allow excess water to drain out. The frame is capable of catching excess water, but if you decide you don't like the frame (I'll try to not let it get to me), I have created trays that will serve just as well.
Print Settings
- Layer Height – 0.2mm
- Material – PETG, PLA, or other
- Infill – 20% Honeycomb
- Perimeters – 2
- Top Fill Pattern – Concentric
- Bottom Fill Pattern – Octagram Spiral
NOTES
While I printed mine without supports, the overhangs are 60 degrees with a few exceeding that, and the corners might curl up a bit. If this concerns you, you may want to print at a lower speed and/or increase the Z-hop to 1.5mm or more (can't be too careful.)
The pot I designed is compatible with all of my frames, do not worry about the fit.
The normal pot has 3mm thick walls. I have not printed the thinner version of the pot yet. It should be thick enough at 1.5mm, but if you print it and experience issues let me know!
My Other Plant Pot Designs