Filament guide for PETPull-2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- GNU General Public License v2.0
Update 24.09.2021
This design operate properly only up to ~20m filament length as reported by community. This is enough for bottles up to 9 litters but not suitable for 30 litters kegs.
Update 18.09.2021
New version of base Spindle_bas_V2 with wide mount wholes to adjust position at mount time.
Description:
This is filament guide for PetPull-2
The design inspired by Artur(@sangalt) idea one from PETPull(Official Group)
Additional materials:
- 6 mm smooth steel rod (60 mm) x1
- M6 DIN125 washer x2
- 4.2x16 DIN968 nail screw to mount x2
Assembly:
- Clean roller whole by 6 mm drill bit until it will rotate on rod without force
- Add some grease to rod and washers
- Add washer on rod at each side of roller
- Mount base inside PetPull-2 machine reducer as close as possible to front (where filament in) and to side opposite to gears (see photos). But you can experiment with base position.
- Put rod to notches in base with significant force until click
P.S. Roller part design files names spindel :)
Print Settings
Printer:
Kingroon KP3
Rafts:
No
Supports:
No
Resolution:
160
Infill:
60
Filament:
Home made PET
Light blue
Notes:
5 perimeters, 5 top and bottom layers. Infill 60%.
Print roller vertically and add brim.
Category: 3D Printer Parts