1 / 9
Improved Phone Stand for phone with popcap / battery case — image 1
1 / 9

Improved Phone Stand for phone with popcap / battery case

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Improved design from the previous version (v6). This design is v7. Simple phone stand designed in FreeCAD to…

Rating
0 / 5
Likes
4
Downloads
71
Makes
0
Views
408
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — NoDerivatives

Improved design from the previous version (v6). This design is v7.

Simple phone stand designed in FreeCAD to accommodate phones with popcaps and / or battery cases. Designed with iPhone 7/8/SE in mind in a slim battery case, both with and without a popcap. Should fit most phones. Your mileage may vary.

Tested in portrait and landscape - popcaps were more or less centered. Also used with 9.7-inch iPad 4 (in portrait only). IF using with iPad, be careful not to topple.

Phones may slide around a bit because the "hook" is large to accommodate phone+battery case.

Channel on underside of feet is for glue-stick glue - for grip / non-slide.

Print Settings

Printer:

FLSUN QQ-s

Rafts:

No

Supports:

Yes

Resolution:

0.3

Infill:

15%

Filament:

Hatchbox PLA PLA

White


Notes:

I used Cura 4.7.1 using "Tree" supports with a skirt. Extruder at 205 and bed at 65 running at 100 mm/s on the FLSUN QQ-s.

This is the 7th iteration to accommodate placement of popcaps and provide for a relatively short print time. I print these in just under an hour.

Post-Printing

For non-slip feature, use hot glue

All I did was squirt a bead of hot glue into the channel and then use a knife blade to press flat and shmoosh the hot glue into the channel.

I put a very light coat of non-stick spray (just barely any) and spread it over knife face. I shmoosh the hot glue and hold the knife until the glue cools a bit, then the knife easily comes off and leaves the glue in the channel.

The channel is supposed to keep the hot glue from peeling off - YMMV.

Another option is Sugru or some other mouldable, rubbery substance.

Category: Mobile Phone

Tags