Phone Stand for phone with popcap / battery case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple phone stand designed in FreeCAD to accommodate phones with popcaps and / or battery cases. Designed with iPhone…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 17
- Makes
- 0
- Views
- 228
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial
Simple phone stand designed in FreeCAD to accommodate phones with popcaps and / or battery cases. Designed with iPhone 7/8/SE in mind in a slim battery case, both with and without a popcap. Should fitmost phones. Your mileage may vary.
Tested in portrait and landscape - popcaps were more or less centered. Also used with 10.5-inch iPad Pro (in portrait only). IF using with iPad, be careful not to topple.
Phones may slide around a bit because the "hook" is large to accommodate phone+battery case.
Channel on underside of feet is for glue-stick glue - for grip / non-slide.
Print Settings
Printer:
FLSUN QQ-s
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
10%
Filament:
Hatchbox PLA
White
Notes:
I used Cura 4.7.1 using "Tree" supports with a skirt. Extruder at 205 and bed at 65 running at 100 mm/s on the FLSUN QQ-s.
This is the 6th iteration to accommodate placement of popcaps and provide for a relatively short print time. I print these in just under an hour.Post-Printing
For non-slip feature, use hot glue
All I did was squirt a bead of hot glue into the channel and then use a knife blade to press flat and shmoosh the hot glue into the channel. The channel is supposed to keep the hot glue from peeling off - YMMV.
Category: Mobile Phone