My Take on Corona Virus Covid-2019 Easy Print No Supports (Some Assembly Required)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is my interpretation of the COVID-2019 Coronavirus. Being stuck at home because of this stupid thing, I decided…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 42
- Makes
- 0
- Views
- 256
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Chemistry & Biology
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my interpretation of the COVID-2019 Coronavirus. Being stuck at home because of this stupid thing, I decided to make a macro plastic version of it.I took inspitation from images online of the corona virus and https://www.thingiverse.com/thing:4166787 but this is not a remix, it is a from scratch design. I dislike supports and I also wanted to make a multicolor version without a multi material printer, so I set to work and designed this thing.
This is very easy to print even on a very small printer. The body is 50mm in diameter and the spikes are a little over 20mm. You will need to print 2 body halves, 1 pin and 45 spikes. I used a brim on the spikes and set the printer to ZHop as not to knock the spikes over while printing. I used some adhesive for car trim to hold it together, but 3d gloop,or super glue, or even hot glue would work fine to assemble it. I printed this in translucent blue PLA and red PLA.
It is a little cartoony in it's dimensions, but it is a good reference piece. I think it would be a good project for all those kids who are out of school during the pandemic shutdown.
I promise that printing this will not infect you with the Virus! Wash your hands and be careful out there!
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
No
Supports:
No
Resolution:
.15 base with variable layer heights
Infill:
10%
Filament: Cheap and Zyltech PLA Translucent Blue and Red
Notes:
I printed this with brims for the Spikes (accidentally left it on for the body and pin). I turned ZHop on to avoid knocking over the pins. You need to print 2 copies of the body, 1 pin and 43 Spikes. I used variable layer heights to speed up printing and have better quality for the top layers.
Assembly
Align the 2 body halves using the hex pin and glue the halves together. Glue the spikes into the printed holes. Easy as that.
I used automotive trim glue to hold it together, but hot glue, superglue, 3d gloop or epoxy would work as well.Category: Biology