B-52 Stratofortress Kit Card
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Kit card of the Boeing B-52 Stratofortress, also known as the BUFF (Big Ugly Fat Fellow). this behemoth has a long reach
- Rating
- 5 / 5
- Likes
- 299
- Downloads
- 1,331
- Makes
- 11
- Views
- 5,373
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The B-52 Stratofortress is an American long-range strategic bomber. The B-52 was put into service in 1955 and has remained in service for over 60 years. The USAF projects that it will serve another 30 years before it is retired. Since its introduction the B-52 has served in several wars. another testament to the B-52 is that many other aircraft have been proposed to put it out of service, such as the B-58 Hustler, B-70 Valkyrie, B-1 Lancer, and B-2 Spirit. There have also been instances were a B-52 has had its tail shot off and still managed to fly home safely.
This is my last entry for the Last Meters contest, uses 3.80 meters of filament.
Both Sprue and Sprue-less models included along with models of individual parts. If you are printing with the individual parts you will want:
Landing Gear Down:
B-52 Stratofortress Kit Card Fuselage Landing Gear Down x1
B-52 Stratofortress Kit Card Wing Spar x2
B-52 Stratofortress Kit Card Wing Landing Gear Down Right x1
B-52 Stratofortress Kit Card Wing Landing Gear Down Left x1
B-52 Stratofortress Kit Card Tail x1
B-52 Stratofortress Kit Card Engine Mount x4
B-52 Stratofortress Kit Card Engine x4
B-52 Stratofortress Kit Card Wing Landing Gear Right x1
B-52 Stratofortress Kit Card Wing Landing Gear Left x1
In Flight:
B-52 Stratofortress Kit Card Fuselage x1
B-52 Stratofortress Kit Card Wing Spar x2
B-52 Stratofortress Kit Card Wing Right x1
B-52 Stratofortress Kit Card Wing Left x1
B-52 Stratofortress Kit Card Tail x1
B-52 Stratofortress Kit Card Engine Mount x4
B-52 Stratofortress Kit Card Engine x4
while the fit is relatively snug, glue is recommended.
Print at a .2 mm layer height with 100% infill.