1 / 9
Piper 2 - T-Rex 5015 Radial Fan Mount — image 1
1 / 9

Piper 2 - T-Rex 5015 Radial Fan Mount

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

The standard axial fan design did not offer enough airflow/cooling for high-speed/higher temp PLA printing on the…

Rating
0 / 5
Likes
0
Downloads
10
Makes
0
Views
178
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

The standard axial fan design did not offer enough airflow/cooling for high-speed/higher temp PLA printing on the Piper 2. I didn't want to re-invent a fan cooler nozzle just yet, but needed the air flow that radial fan's produce.

Packaging is a challenge since there is less than 25mm to position a vertical fan to either the front or the back of the Piper 2 X-Carriage.

With the suggestion of another Piper 2 builder, I'm using the T-Rex MK3 fan. I've asked the T-Rex designer if he could make the mount hole a little smaller and extend a flange so the 5015 fan can snap into the nozzle. My tests have been good with the current T-Rex MK3 design.

Yellow part is the fan/cooler nozzle mount

Red part is the T-Rex MK3 Nozzle : https://www.thingiverse.com/thing:2022857

5015 Radial Fan (12v, 24v, and 5v options): https://www.amazon.com/gp/product/B07DB7DLMM

Purchase Parts:

6-32 x 3/4" taper head screws w/nuts. I used 1" long screws cut down to 3/4" long

6 x 3/8" sheet metal screw - holds mount and T-Rex fan together.

Note: Round head screws may scrape on the gantry EMT pipe.

T-Rex is centered to E3D nozzle, about 1mm up from Z0 and about 13mm back. T-Rex nozzle directs air flow down on print, not across the top of the nozzle.

Benchy Images - Left hand benchy is T-Rex and 5015 radial fan, right hand bency is axial fan cooler. Both printed at 150mm/s and 228C on a heated glass bed.

Print Settings

Printer:

Anet A8

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

0.2mm

Infill:

25% to 35%

Filament:

3D Solutech PETG

Real White


Notes:

You may want to add supports just for the angled arm. I've printed with and w/o supports and it printed just fine.

Category: 3D Printer Parts

Tags