1 / 4
Ender 3 PITFT50 Display Shroud and Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Allows a 5 inch tft DSI touch screen to be mounted on an ender 3.
- Rating
- 0 / 5
- Likes
- 26
- Downloads
- 86
- Makes
- 0
- Views
- 1,417
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is a Bigtreetech PITFT50 Display shroud and mount designed for the ender 3, it is designed to be mounted where the original stock display is mounted.
Unfortunately this design does not allow for the raspberry pi to be directly mounted to the screen so an external pi mount and an appropriate length ribbon cable of your choosing will be needed to use this mount
BOM:
Non Printed:
- 1 PITFT50
- 8 M3 X 5 X 5 or M3 X 3 X 5 Insert (Optional, Choose Appropriate Display lock between a 5mm wide insert, 3mm wide insert or no insert)
- 8 M3 X 5 BHCS/SHCS
- 2 M5 x 5 BHCS/SHCS
- 1 M5 x 30 BHCS/SHCS
- 1 M5 Nut
Printed:
- 1 Main Case
- 4 Display Lock
- 1 Case - Mount Interface
- 1 Mount
Assembly Notes:
- The Main case can be flipped 180 Degrees if need be, although it may need a software display rotation within your pi firmware, the photos shown are in its flipped state, and needed a firmware rotation.
- The Mount has a mirrored version if there is a need to mount it on the other side of the printer instead.