Spooky Eye Pixel Box - v2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A ground up redesign of last years box. This box prints as 1 piece and does not need supports. This box is meant for 4…
- Rating
- 5 / 5
- Likes
- 36
- Downloads
- 287
- Makes
- 2
- Views
- 1,354
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A ground up redesign of last years box. This box prints as 1 piece and does not need supports.
This box is meant for 4 12mm RGB Pixels, each eye has 2 behind it.
The design allows for an optional difuser to be able to block off light for each eye.
The eyes were created from https://www.thingiverse.com/thing:3155043/files, special shout out to the author for making these available.
The idea spooky eye box was taken from Spooky Eyes by Boscoyo (https://boscoyostudio.com/product/spooky-eyes/)
The goal of printing was study but least amount of filament as needed. Suggested to use PETg as this will be in the sun.
Print Settings for all parts
.3mm layer height
.44mm line width
.88mm wall thickness (2 walls)
1.2mm top/bottom layers (4 layers)
25% infill
Category: Electronics
*** To use the attached XModel, remove the .txt extension ***