Raspberri Pi case with open top and botton
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made a more open case for my RPI based off 0110-M-P's much used design. I made more room for your fingers to get the…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 25
- Makes
- 0
- Views
- 217
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution
I made a more open case for my RPI based off 0110-M-P's much used design.
I made more room for your fingers to get the SD card out.
This one screws together with M3 bolts and comes in two heights to allow for a slim fit or a 15 mm heatsink.
I print it with 0.40mm nozzle (0,48 as per simplify 3d auto setting), 0.2mm layer height in ABS, layers, 3 top, 3 bottom, 3 outline. 45mm/s and a low setting for the part cooler.
Don't go too slow in print speed or you will melt the four screw towers
2018 July 27
Added top with clearance for 15mm high passive heat and side mounting for 2020 extrusions
Category: DIY