5x7 dot matrix Tag

* This is a design for the contest. I think all users have the same problems. Thank you for the good contest.

It is a design to use up the last filament.
If you're wondering how to use up the filament, print this tag.

<Design conditions>

Designed under the following conditions.

1. Being able to print with a small amount of filament.
   1-character tag is 0.24 meter.
   2-characters tag is 0.35 meter.
   3-characters tag is 0.48 meter.
   4-characters tag is 0.61 meter.
2. It is not a dedicated design, but versatile.
   If you engrave characters on a 3D model, it will lose its versatility, so it is a method of painting with an oil-based marker later.
3. Solving the problem of capillarity.
   It has a convex dot matrix to solve the problem that bleeding along the print line tends to occur when applied with an oil-based marker on a flat surface. The marker does not blur.
   Please refer to the 5x7 dot matrix pattern site(ex.fontstruct) for the painting pattern.
4. Easy to customize.
   It is a divided design. You can customize it with the required number of characters.

<Description>

[tag_dot_matrix_7-5x1.stl]

5x7 1-character tag

[tag_dot_matrix_7-5x2.stl]

5x7 2-character tag  / (5 + 1 + 5) x 7 dot

[tag_dot_matrix_7-5x3.stl]

5x7 3-character tag  / (5 + 1 + 5 + 1 + 5) x 7 dot

[tag_dot_matrix_7-5x4.stl]

5x7 4-character tag  / (5 + 1 + 5 + 1 + 5 + 1 + 5) x 7 dot

[tag_dot_matrix_7-5_26hole.stl]

End parts for one character / with keychain hole / width 17 mm

[tag_dot_matrix_7-5_middle.stl]

Middle parts for one character / width 12 mm

[tag_dot_matrix_7-5_nohole.stl]

End parts for one character / no keychain hole / width 13 mm