Anet A8 Bed Leveling Knob
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I know there are others out there, but I ran into an issue where the other one I printed was too large and hit the…
- Rating
- 4.5 / 5
- Likes
- 18
- Downloads
- 206
- Makes
- 5
- Views
- 565
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
I know there are others out there, but I ran into an issue where the other one I printed was too large and hit the front of the frame. These are pretty much the size of the wing nut (A little taller due to the bottom layer.)
These work well with or without the drilling of the H frame. I found the rear wing nuts difficult to reach at times during leveling. These help a great deal.
They fit the factory wing nuts very tight. I pushed them in with a screw driver and seated them the remaining amount by threading them on.
These were printed in Hatchbox PLA.
Thanks for checking it out. We are open to all input and comments.
As always, Print On!
Print Settings
Printer:
Anet A8
Rafts:
No
Supports:
No
Resolution:
.2
Infill:
30%
Notes:
I printed these with a .8 wall thickness.
Category: Electronics